# Question: What Amp Should You Charge A Deep Cycle Battery?

## Is it better to charge a battery at 2 amps or 10 amps?

A basic charger usually charges at around 2 amps – and so needs 24 hours to deliver the 48 amps needed to fully charge a flat, 48 amp hour battery.

But there is a wide range of chargers with different charge rates on the market – from 2 to 10 amps.

The higher the charge output, the faster a flat battery is recharged..

## How long does it take to charge a 100ah deep cycle battery?

14 hoursSo to charge a 100A-hr battery would take (100A-hr)/7.083A, which is a little over 14 hours. This means that a fully discharged battery can be expected to take on the order of 14 hours of direct sunlight if the panel can be oriented towards the sun during the charge time.

## How often should you charge a deep cycle battery?

Batteries should be equalized occasionally to make sure each cell is equally charged. Apply a controlled overcharge once every 30-90 days, or whenever individual batteries are imbalanced (reading a different voltage or specific gravity).

## How many solar panels does it take to charge a deep cycle battery?

Using this example, you can see that it will take at least 100 watts of solar power to recharge a 100-amp hour battery in a few days. Also, keep in mind that it takes direct sunshine on the surface of the panel to produce the maximum-rated power of a solar panel.

## Can you charge a deep cycle battery with a regular charger?

Using a traditional battery charger to recharge your deep cycle battery will not give you the best possible results. This is because excess heat is produced whenever a battery is charging. A deep cycle battery is not designed to handle the rapid charging and extra heat, so it may never reach full capacity.

## How long does it take to charge a deep cycle battery at 10 amps?

15 hoursFor round numbers takes a 150 amp deep cycle battery. Charge it at 10 amps, you will need to charge that battery for up to 15 hours to fully charge as it puts up to 10 amps in each hour.

## How fast can you charge a deep cycle battery?

The time it takes to properly charge a battery depends on its current discharge value and your charger’s amperage specification. A charger with 15 amps, for instance, will take about two hours to fully charge a battery at a 25-percent discharge value.

## What is the best type of charger for deep cycle batteries?

Top 3 Best RV Battery Chargers – ComparisonNameEditor RatingNOCO Genius GENM2 8 Amp 2-Bank On-Board Battery Charger4.7 out of 5Battery Tender 2-Bank 12V, 1.25A Battery Charger, Perfect for all AGMs4.6 out of 5BatteryMinder AMP Battery Charger-Maintainer-Desulfator4.5 out of 5

## Should you trickle charge a deep cycle battery?

Some lose energy quicker than others, which is the purpose of a trickle charger. Deep-cycle batteries do not need to be at 100% to be used, although fully charging the battery after use extends its lifespan.

## How do you charge a deep cycle battery with a battery charger?

Set your battery charger to a slow or trickle charge and select whether you are charging a 6, 12 or 24 volt deep cycle battery. If your battery charger has the option to set the voltage for the charge, set it to 20 percent of the rated amp per hour rate of the battery you are charging.

## What should a fully charged 12v deep cycle battery read?

Voltage on a fully charged battery will read 2.12 to 2.15 volts per cell, or 12.7 volts for a 12 volt battery. At 50% the reading will be 2.03 VPC (Volts Per Cell), and at 0% will be 1.75 VPC or less. Specific gravity will be about 1.265 for a fully charged cell, and 1.13 or less for a totally discharged cell.